Using the Gradient Tool

While the Develop tools allow you to make a variety of adjustments to your photos, sometimes you want these effects to gradually progress across your photo. You can adjust the Exposure, Saturation, Vibrance, Temperature, Tint, Fill Light, Contrast, Clarity, and Color Strength, as well as Color EQ, Tone Curves, and Sharpness in one or a series of gradients over your photo. For example, instead of applying exposure adjustments across an entire photo, you may want them to be stronger in some areas and weaker or absent from others.

Gradient Tool

The Gradient tool button displays at the top of Tune and Detail tab.

To Use the Gradient Tool:

  1. In Develop mode, on the Tune or Detail tab, click the Gradient button at the top of the pane to open the control panel and enter gradient mode. Or, toggle the Gradient panel open and closed with the G key.
  2. Specify the gradient settings in the panel as described in the table below.
  3. Position the guides on your photo. Inside the guide boxes, the gradient is transitioning. On either side of the boxes, the effect being applied by the Gradient tool is at full strength or not applied at all. To make this clearer, check the Show gradient mask checkbox. Move the boxes to define where the effect will begin or end. Hold down the Shift key while positioning the effect to lock to the nearest 45° angle, for straightness.
  4. Adjust the sliders to get the effect you want.

  5. To apply another mask, (up to 24 are available), click the + on the bottom left of the panel and select a masking option. A new icon (related to the type of mask selected) will appear in the Masks section. Your currently selected mask will be outlined in blue. You can reselect any of the masks at any given time by clicking its respective icon.

  6. Press Apply or Done.

Gradient Tool Options

Invert gradient

Toggle this option to invert the gradient. By pressing the Invert button after applying a gradient beginning at the top of the image, the gradient would now begin at the bottom, and vice versa.

Show mask

When this option is checked, your gradient mask will be displayed in the color shown. Alternatively, hold down the S key to see the mask on the image. Click the drop-down arrow to select another display color.

Using the Gradient Tool on the Detail Tab

Sharpness

Move the Sharpness slider to the right to sharpen the area affected by the gradient, or move the slider to the left to blur the area affected by the gradient.

To exit Gradient mode, toggle the back button.